A wall-climbing robot that is capable of transitioning from the ground to the wall.

The robot has two tiltable propellers that provide thrust onto the wall, and four wheels. One pair of wheels is steerable, and each propeller has two degrees of freedom for adjusting the direction of thrust. The use of propellers to provide thrust onto the wall ensures that the robot is able to traverse over indentations such as masonry. 

The choice of two propellers rather than one enables a floor-to-wall transition - thrust is applied both towards the wall using the rear propeller, and in an upward direction using the front propeller, resulting in a flip onto the wall.

VertiGo

The robot has two tiltable propellers that provide thrust onto the wall, and four wheels. One pair of wheels is steerable, and each propeller has two degrees of freedom for adjusting the direction of thrust. The use of propellers to provide thrust onto the wall ensures that the robot is able to traverse over indentations such as masonry.&nbsp;The choice of two propellers rather than one enables a floor-to-wall transition - thrust is applied both towards the wall using the rear propeller, and in an upward direction using the front propeller, resulting in a flip onto the wall.Weight is minimized by using a central carbon fibre baseplate, while 3D-printed parts in conjunction with carbon-rods are used for more complex three dimensional structures like the wheel suspension or the wheels themselves.&nbsp;The baseplate provides mounting points for two thruster modules and the wheel suspensions. It also serves as carrier for all the electronic parts and wires. The thrusters are mounted using a two-ringed Cardan Suspension. Integrated servomotors allow the inner and outer ring to be moved independently from one another. This supports the generation of all the forces required to drive on the floor, on walls and theoretically even on the ceiling.&nbsp;The wheels are mounted with a double wishbone suspension based on model-car oil dampers, but they are not propelled in any way. The full design has eight individually controlled actuators. To enable a human operator to conveniently drive the vehicle in a way similar to common RC-cars, an onboard computer is incorporated as a controller. It uses data from a 6-axis IMU in the centre of the robot as well as from two infra red distance sensors mounted in front to estimate its orientation in space. Based on this attitude information, the controller then devises the best positions for all actuators to achieve a desired user input

Short description of the Vertigo project and the technical background.

VertiGo - a Wall-Climbing Robot including Ground-Wall Transition

Measurement

Actuators

Vision

Thrusters

Materials

A wall-climbing robot that is capable of transitioning from the ground to the wall.

Measurement	6-axis IMU in the centre of the robot
Actuators	8	individually controlled
Vision	2	infra red distance sensors
Thrusters	2	(mounted using two-ringed Cardan Suspension)
Materials	3D-printed parts
	Carbon