An exoskeleton that reduces joint loading, muscle fatigue, or metabolic demand of walking.

This is an exoskeletal architecture for augmenting running leveraging a spring–clutch exoskeleton consisting of a custom interference clutch with an integrated planetary gearbox.

Specifications for the exoskeletal joint were derived from existing biomechanical data. The design also includes a control system to enable clutch locking and unlocking throughout a running gait cycle. 

Clutch spring knee exoskeleton

This is an exoskeletal architecture for augmenting running leveraging a spring–clutch exoskeleton consisting of a custom interference clutch with an integrated planetary gearbox.Specifications for the exoskeletal joint were derived from existing biomechanical data. The design also includes a control system to enable clutch locking and unlocking throughout a running gait cycle.&nbsp;The elastic element of the exoskeleton consists of thin strips of semirigid unidirectional “E” fiberglass laminate located proximal and distal to the lockable exoskeletal joint. The net system constitutes a compression spring, characterized by the geometry of these elastic elements.&nbsp;The exoskeletal joint consists of an interference clutch (chosen for its high ratio of holding torque to mass) in series with a planetary gearbox which decreases the load on the clutch plates and increases effective resolution, compensating for the discretized engagement of the interference clutch.&nbsp;Electronics are housed in a lateral subassembly with only a single pair of wires necessary to connect to the solenoid. A quadrature phase encoder for measuring the exoskeletal joint angle and a break beam for measuring solenoid position are both interfaced optically. The sensor suite is completed by a three-degrees of freedom sagittal plane inertial measurement unit.&nbsp;

Introduces the project and its motivation. Describes the elastic element design, clutched exoskeletal joint, and electrical systems. Discusses the results of the research and mechanical validation.



Design of a Clutch–Spring Knee Exoskeleton for Running. 

Paper investigates the hypothesis that the addition of an external elastic element  at the knee during the stance phase of running results in a reduction in knee extensor activation so that total joint quasistiffness is maintained.



The Biomechanics and Energetics of Human Running using an Elastic Knee Exoskeleton.

Describes the design of two elastic leg exoskeletons that act in parallel with the wearer’s legs. Tests hypotheses by measuring GRFs, exoskeletal compressions, and metabolic rates.



Leg exoskeleton reduces the metabolic cost of human hopping.

Mass 

Diameter 

Thickness 	 

Holding torque 

Radial load 

Axial load 	 

Engagement time 	

Resolution 

Range of motion 

Battery 

Processor	 

Sensors 

Data storage	 

An exoskeleton that reduces joint loading, muscle fatigue, or metabolic demand of walking.



Mass	710	g
Diameter	85	mm
Thickness	49	mm
Holding torque	190	(T) (Nm)
Radial load	4780	(Fr) (N)
Axial load	4050	(Fa) (N)